Yamaha TF3

Baserat på 9 Omdömen

Beskrivning:

Yamaha TF3

 

  • 25 motoriserade faders (24 kanalfaders + 1 master)
  • 48 ingångar för mix (40 mono + 2 stereo + 2 retur)
  • 20 Aux (8 mono + 6 stereo) + Stereo + Sub bussar
  • 8 DCA-grupper med utrullning
  • 24 analoga XLR/TRS combo mic/line ingångar + 2 analoga stereo phono line ingångar
  • 16 analoga XLR-utgångar
  • 34 x 34 kanaler digital ingång och uppspelning via USB 2.0 + 2 x 2 via ett USB-minne
  • 1 expansionskortplats för NY64-D interface

Prismatch och säker leverans

41.190 kr.
Vi prismatchar i
Utsåld - Kontakta oss för leveranstid

Vi rekommenderar även dessa produkter



  • Massor av inputs.
  • Praktisk kontroll för de flesta situationer.
  • Massor av alternativ i ett kompakt skrivbord.

Specifikationer:

Modell/Varunr.: YAM-TF3
EAN: 4957812560313

Specifications

Outline

Fader Configuration 24 + 1 (Master)
Mixing Capacity Input Channels 48 (40 mono + 2 stereo + 2 return)
Aux Buses 20 (8 mono + 6 stereo)
Stereo Buses 1
Sub Buses 1
Input channel functions 8 DCA groups
I/O Inputs 24 mic/line (XLR/TRS combo) + 2 stereo line (phono)
Outputs 16 (XLR)
Expansion slots 1
On-board processors DSP 8 effects + 10 GEQ
USB 34x34 USB Audio Interface, 2-track recording to USB stick

General specifications

Sampling frequency rate Internal 48 kHz
Signal delay Less than 2.6 ms, INPUT to OMNI OUT, Fs=48 kHz
Fader 100 mm motorized, resolution = 10-bit, +10 dB to -138 dB, - dB all faders
Total harmonic distortion Less than 0.05% 20 Hz-20 kHz @+4 dBu into 600 ohms, INPUT to OMNI OUT, Input Gain=Min. (Measured with a -18 dB/octave filter@80 kHz)
Frequency response +0.5, -1.5 dB 20 Hz-20 kHz, at +4 dBu output @1kHz, INPUT to OMNI OUT
Dynamic range 110 dB typ., DA-converter, 107 dB typ., INPUT to OMNI OUT, Input Gain=Min.
Hum & noise level Equivalent input noise -128 dBu typ., Input Gain=Max. (Measured with A-weighting filter)
Residual output noise -85 dBu, ST master off (Measured with A-weighting filter)
Crosstalk -100 dB (Measured with a -30 dB/octave filter@22 kHz), consecutive INPUT/OMNI OUT channels, Input Gain=Min.
Power requirements 100-240 V 50/60 Hz
Power consumption 110 W
Dimensions W 716 mm (28.2in)
H 225 mm (8.9in)
D 599 mm (23.6in)

General specifications

Net weight 17.0 kg (37.5lb)

General specifications

Accessories Quick Guide, Power cable, CUBASE AI download information
Options Expansion card, foot pedal (FC5)
Others Working temperature: 0-40 °C, Storage temperature: -20-60 °C

Analog input characteristics

Input Terminals GAIN Load
Impedance
For Use With
Nominal
Input Level Connector balanced /
Unbalanced
Sensitivity*1 Nominal Max. before clip
INPUT1-24 +66dB 7.5K 50-600 Mics
or 600 Lines
-82dBu (61.6 V) -62dBu (0.616mV) -42dBu (6.16mV) Combo Jack (XLR-3-31 type *2
or TRS phone *3)
Balanced
-6dB -10dBu (245mV) +10dBu (2.45V) +30dBu (24.5V)
ST IN 1,2 - 10k 600 Lines -30dBV (31.6 V) -10dBV (316mV) +10dBV (3.16V) RCA Pin Jack Unbalanced

*1. Sensitivity is the lowest level that will produce an output of +4dBu (1.23V) or the nominal output level when the unit is set to maximum gain. (All faders and level controls are at maximum position.)
*2. 1: GND, 2: HOT, 3: COLD
*3. Tip: HOT, Ring: COLD, Sleeve: GND
*In these specifications, 0dBu = 0.775Vrms.
*+48V DC (phantom power) can be supplied to INPUT XLR type connectors via each individual software controlled switch.

Analog output characteristics

Output Terminals Source
Impedance
For Use With
Nominal
GAIN SW Output Level Connector balanced /
Unbalanced
Nominal Max. before clip
OMNI OUT 1-16 75 600 Lines "+24dBu" position (default)
 
+4dBu (1.23 V) +24dBu (12.3 V) XLR-3-32 type *1 Balanced
PHONES *3 100 40 Phones - 3mW 75mW Stereo Phone Jack (TRS) *2 Unbalanced

*1.1: GND,2: HOT, 3: COLD 
*2 Tip: LEFT, Ring: RIGHT, Sleeve: GND 
*3 The position of the level control is lowered by 16dB from the maximum.
*In these specifications, 0dBu = 0.775Vrms. 
*All output DA converters are 24bit, 128times oversampling.

Digital input/output specifications

Terminals Format Data length Audio Connector
USB (TO HOST) USB 24bit 34ch input / 34ch output, PCM USB (B type)
iPad USB - Playback: MP3 or WAV file data / Record: WAV file data USB (A type)

 

Control I/O specifications

Terminals Format Level Connector
NETWORK IEEE802.3 10BASE-T/100Base-TX RJ-45
FOOT SW - - TS Phone